Adapter For Other Mounting Systems; Troubleshooting - Silvercrest SCW 5 A2 User Manual And Service Information

SilverCrest SCW 5 A2

Adapter for other mounting systems

The camcorder also includes an adapter for other mounting systems. You can use this
adapter to fix the camcorder with other mounting systems. You can connect this adapter to
the water-resistant case. Proceed as follows:

Slide the adapter for other mounting systems into the adapter of the water-resistant case
until it clicks into place. Then you can use other standard mounting systems.

Press the clip on the adapter for other mounting systems to remove the adapter for other
mounting systems from the water-resistant case.

Troubleshooting

You can solve most common problems yourself using the table below. If the problem persists
after checking the suggested solutions, please contact our Service Hotline (see page 77). Do
not attempt to repair the product yourself. Do not open the housing of the camcorder as it
contains no serviceable parts.
Error
Unable to power the
camcorder on.
The camcorder suddenly
powers off.
The camcorder suddenly
powers off.
The camcorder fails to respond
and cannot be switched off.
The recordings show stains or
shadows.
72 - English
Solution
The battery pack is empty. Recharge the battery.
The battery pack is empty. Recharge the battery.
Auto power-off is enabled. Check the setting (see
page 45).
Remove the battery pack for a few seconds and re-
insert it.
Use a dry, soft, line-free cloth and clean the
camcorder lens. Do not use any detergents or
chemicals.