Connection; Clothing; Operation - Texas A/S ETB1000-S User Manual

Disconnect power and pull out the plug.
Turn the black lower part of the gear gear
until you see a hole in the groove. Put the
stick into the hole on the gear to block the
gear.
Fit the trimmer head by turning it to the left.

Connection

The trimmer may only be connected to single-phase AC current 230 Volt 50 Hz. It has
protective insulation and may therefore be connected to the socket without a protective
conductor. Before use make sure that the mains voltage is the same as the operation
voltage indicated on the rating plate of the trimmer.

Clothing

When using the machine, wear tight-fitting work
clothes, strong working gloves, hearing protectors and
boots with non-skid soles.

Operation

To start the trimmer press the ON/OFF
switch
Stop the trimmer by releasing the main
switch.
Allow at least 5 seconds for the trimmer
head to stop rotating.
ON/OFF switch
www.texas.dk
13