Electrical Wiring Connection - Acson WM07GW Installation Manual

IMPORTANT : The figures shown in the table are for information purpose only. They should be checked and selected
to comply with the local/national codes of regulations. This is also subject to the type of installa-
tion and conductors used.
A main switch or other means for disconnection, having a contact separation in all poles, must be
incorporated in the fixed wiring in accordance with relevant local and national legislation.
Model
Voltage range
Power supply cable size
Number of wire
Recommended fuse
• All wires must be firmly connected.
• All wires must not touch the water piping, or any moving
parts of the fan motor.
• The connecting wires to the indoor unit must be clamped
on the wire clamps as shown in the figure.
• The power supply cord must be equivalent to H05VV-F
(60227 IEC 52 or 60227 IEC 53) which is the minimum
requirement, and to be used in protective tube.

ELECTRICAL WIRING CONNECTION

WM07GW / WM10GW / WM15GW
2
mm
A
WM07-25GW
Chiller
1-5
WM20GW / WM25GW
220V – 240V/1Ph / 50Hz +
1.5
3
2
Wire Clamp
Interconnection
Cable
1.5
3
2
Power Supply
Cable
3 way valve
Relay (220-240V, 10A)