Lenovo B300 Product Manual page 7

Adaptive Networking
Bottleneck detection: Identifies devices attached to the fabric that are slowing down traffic.
Ingress rate limiting: Restricts the speed of traffic from a particular device to the switch port.
Traffic isolation zoning (TIZ): Creates a dedicated path for traffic flowing from a specific set
of source ports (F_Ports).
Quality of Service (QoS): SID/DID traffic prioritization
Virtualization
N_Port ID virtualization (NPIV): Enables a single FC port to appear as multiple, distinct ports
with separate port identification within the fabric.
Access Gateway (requires all 24 ports be licensed): Leverages NPIV to connect to any fabric
without adding switch domains to reduce management complexity.
Management
IPv4 and IPv6 addressing
Firmware upload and download
Hot code load and activation
Network Time Protocol (NTP) v3
EZ Switch Setup Wizard
Command line interface (CLI)
Web Tools
Brocade Network Advisor (purchased separately)
SNMPv1, SNMPv3, and MIBs
SMI-S compliant
Syslog
Security
Local switch user accounts
LDAP, RADIUS, TACACS+ user authentication
Role-based access control (RBAC)
Administrative Domains: Partition the fabric into logical groups and allocate administration of
these groups to different user accounts
IP Security (IPsec)
IP filtering with access control lists (ACLs)
HTTPS
Secure Copy (SCP)
Secure RPC
Secure FTP (SFTP)
Secure Shell (SSH) v2
Secure Sockets Layer (SSL)
Federal Information Processing Standards (FIPS) 140-2 L2-compliant
Advanced Diagnostic Tools
Power-on self-test (POST)
MAPS basic monitoring: Monitors system resources and overall switch health status.
Event logging
Environmental monitoring
FCping
Pathinfo (FC traceroute)
Non-disruptive daemon restart
Port mirroring
Port fencing: Disables a port if specified error conditions are met.
RAS trace logging
Lenovo B300 FC SAN Switch 7