Bosch FPA-1000-UL Installation And Operation Manual page 89

Analog fire panels
PAS Reset Screen
Fire Alarms:
Press v To View
Investigating
RESET Within 180 Seconds
The example shows a programmed PAS investigation time of 180 seconds (= default).
The time is counted down until time-out. Without reset, the system switches back to the
general Fire Alarm screen. If [RESET] is pressed within delay time, the system shows the PAS
Reset screen. If the point is not in alarm, it will then go to normal screen. If the point is still in
alarm, it will display investigating again.
Gas Alarm Screen
Gas Alarms:
Press v To View
Press </> To View
Fire Alarms/Supervsr
The example above shows three gas alarm messages. Press [∧] or [∨] to view individual gas
alarm screens.
GAS ALM [pp - l - aaa.s]
[MM/DD/YY hh:mmayyy/xxx]
[Device Type]
Point Label
Supervisory Screen
Supervisories:
Press v To View
Press </> To View
Gas Alarms/Troubles
The example above shows five supervisory messages. Press [∧] or [∨] to view individual
supervisory screens.
SUPERVSR [pp - l - aaa.s]
[MM/DD/YY hh:mmayyy/xxx]
[Device Type]
Point Label
Trouble Screen
Troubles:
Press v To View
Press </> To View
Supervsr/Fire Alarms
The example above shows 100 trouble messages. Press [∧] or [∨] to view individual trouble
screens.
Bosch Security Systems, Inc.
1
3
5
100
Installation and Operation Guide
Monitoring, Operating, and Programming | en
2017.11 | 2.0 | F.01U.173.607
89