Table of Contents
Advertisement
LightPack LED Module
PREFACE
About this Guide
The document provides installation and operation instructions for the following products:
•
71361 – LightPack LED 120V, Grounded Stage Pin Connector (GP)
•
71362 – LightPack LED 120V, Twistlock Connector (GTL)
•
71363 – LightPack LED 120V, Edison Connector (GR)
•
71364 – LightPack LED 230V, Bare Leads (no AC input connector installed)
Please read all instructions before installing or using this product. Retain this guide
for future reference.
IMPORTANT INFORMATION. PLEASE READ!
This unit is intended for installation in accordance with the National Electric Code® and local
regulations. It is also intended for indoor applications only. Before any electrical work is
performed, disconnect power at the circuit breaker or remove the fuse to avoid shock or
damage to the control. It is recommended that a qualified electrician perform this installation.
Observe the following precautions when installing, operating or servicing the product:
•
Disconnect power before servicing.
•
Install in dry locations only.
•
DO NOT power module from a dimmed source. Connect to standard power or
mechanical relay ONLY.
•
Use the included safety cable for ALL installations.
•
If installing any other type of mounting hardware or bracket, DO NOT use screws
longer than 1/4" in length. Longer screws WILL damage interior electrical components.
ACCESSORIES
The following accessories are available for the LightPack LED Module from your Authorized
Strand Lighting Dealer. Note, all accessories are sold separately.
Clamps
Part Number
DMX512 Termination
Part Number
SC
71351
71346
Installation & Operation Guide
Description
Pipe Clamp
Cheeseboro Clamp
Description
DMX512 Terminator
3
Advertisement
Table of Contents
