Table of Contents
Advertisement
LightPack LED Module
INSTALLATION
The LightPack LED Module can be mounted in a variety of configurations. Depending on
your requirements, choose one of the methods shown below. The LightPack LED Module can
be mounted vertically (recommended) or horizontally as required, however, to allow for
optimum convection cooling, the module cannot be mounted with the heatsink fins downward.
WARNING: A non-removable safety cable is supplied with the unit. The safety cable
must be attached to a secure structure and may be required by local or national codes.
Wall Mounting
The LightPack LED Module can be mounted to a wall. Note that the wall mounts (with
screws) are included with unit. Wall anchoring hardware is by others. The unit must be
mounted with the heatsink fins up/down so the unit will dissipate heat properly. Mounting to
wall must comply with local and national codes.
Note heatsink orientation.
Mount as shown for proper
cooling.
Pipe Mounting
The LightPack LED Module can be mounted on pipe or truss. Note that the pipe mount (with
screws) are included with unit. Clamps are sold separately or by others (See "Clamps" on
page 3 for ordering information). The unit must be mounted with the heatsink fins up/down so
the unit will dissipate heat properly. Mounting to pipe or truss must comply with local and
national codes.
Note heatsink orientation.
Mount as shown for proper
cooling.
Figure 3: LightPack LED Module Pipe or Truss Mounting
Figure 2: LightPack LED Module Wall Mounting
Installation & Operation Guide
Wall Mount Bracket (x2)
Bracket Mounting
Screws (x4)
Pipe Mount Bracket
Bracket Mounting
Screws (x4)
Wall Mount Brackets*
*As an option, you can reverse the wall
mount brackets and install them as shown
for storage purposes. If the wall mount
brackets are installed in this fashion, all
four mounting screws are used.
5
Advertisement
Table of Contents
