Tpms Transmitter Check Or Replace; Tpms Special Function - Mitsubishi Mirage 2015 Workshop

31-42
WHEEL AND TIRE
ON-VEHICLE SERVICE

TPMS TRANSMITTER CHECK OR REPLACE

After removing the tire from the wheel, remove the TPMS trans-
mitter(Refer to P.31-47). Then check it as follows and replace if
necessary:
1. Wipe off the agent remained on the TPMS transmitter
housing. In particular, remove it thoroughly around the
pressure detection hole.
NOTE: Wait for a while to allow the agent to set, and then
detach it.
2. If any of the following conditions is found, replace the TPMS
transmitter and then register the tire pressure sensor ID
code: In addition, replace the valve, the valve core and the
cap. Then install the tire assembly to the wheel (Refer to
P.31-47).
 Damage (deformation or scratch, etc.) on the exterior of the
housing
 The agent cannot be removed thoroughly from inside the
pressure detection hole.
3. If the conditions above are not found, the TPMS transmitter
can be reused. Replace the valve, the valve core and the
cap only. Then install the tire assembly to the wheel (Refer
to P.31-47).
NOTE: If the TPMS transmitter is reused, the pressure mea-
surement function should be checked as follows.
.

Inflate the corresponding tire to 250 kPa (36.2 psi) or
more, and perform step 2 in the TPMS transmitter check
(Refer to P.31-44).

Inflate the corresponding tire to 150 kPa (21.7 psi) or
less, and perform step 2 in the TPMS transmitter check
(Refer to P.31-44).
If abnormal pressure difference[20 kPa (2.9 psi) or more] is
observed in these checks, replace the TPMS transmitter and
register the tire pressure sensor ID code.

TPMS SPECIAL FUNCTION

TIRE PRESSURE SENSOR ID REGISTRATION
 "Tire Pressure Sensor ID Registration": To enter the ID into
Set 1 when the TPMS transmitter or the ETACS-ECU
<vehicles without Keyless Operation System> or
KOS&OSS-ECU <vehicles with Keyless Operation Sys-
tem> is replaced.
 "Tire PRS. Sensor ID Reg.(Set2)": To enter the ID into Set 2
when the TPMS transmitter or the ETACS-ECU <vehicles
without Keyless Operation System> or KOS&OSS-ECU
<vehicles with Keyless Operation System> is replaced.
TSB Revision
M1311008500028
M1311003900162