Maintenance And Troubleshooting Maintenance - MK Diamond Products MK-100 JCS Owner's Manual & Operating Instructions

MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE:
1. New Maintenance:
Perform the following after initial purchase and operation of the MK-100.
Inspect
V-belt
(A)
Check and adjust V-belt
st
tension Following 1 48 hours of
operation (See V-belt Inspection)
2. Maintenance Following Use:
To extend the life of the MK-100, the following procedure should be performed after each use. Lubricate all
points listed below with light oils such as, 3 in 1, WD-40, etc.
ON/OFF Off
GFCI
Guide Bar
Switch
Position
(B) (C)
(A)
Unplug MK-100 Lubricate the Guide Bar
Ensure the ON/OFF Switch
is in the OFF position
Roller Wheel
Assembly
(A)
Lubricate the Roller
Wheel Assembly
MK-100 JCS Tile Saw Revision 06/05, Effective Date June 27, 2005 Page 29