Advertisement
Operation Guide ANA(G3H-2)
Charging Time to Recover from Dead Battery
Approximate Charging
Exposure Level
Time to 1-second
(Brightness)
Hand Movement
Outdoor sunlight (50,000 lux)
2 hours
Sunlight through a window
6 hours
(10,000 lux)
Daylight through a window on
10 hours
an overcast day (5,000 lux)
Indoor fluorescent lighting
96 hours
(500 lux)
Note
Actual charging time depends on environmental conditions.
E-10
Module 5557 5564
Hour Hand
Stopwatch Minute Hand
Second Hand
Stopwatch Second Hand
Stopwatch functions
E-12
To change the day indicator setting
1. Pull the
Crown
out to Click 1.
2. Rotate the
Crown
towards you to set the day.
3. Push the
back in.
Crown
Note
The day indicator setting uses a 31-day month. Make adjustments for months of
shorter lengths.
Avoid changing the day indicator setting between the hours of 9 p.m. and 1 a.m.
Otherwise, the day indicator may not change correctly at midnight.
E-14
Two finishes
A
B
A
Start
Split
Stop
First runner
Second runner
finishes.
finishes.
Display time of
first runner.
Important!
Do not operate the stopwatch with the crown pulled out.
Note
An elapsed time operation will stop automatically at the end of 30 minutes.
E-16
Specifications
Accuracy at normal temperature: ±20 seconds a month
Stopwatch: Measuring Capacity: 29'59" (30 minutes)
Measuring Unit: 1 second
Measurements: Elapsed time; split time; two finishes
Other: Low battery alert
Power Supply: Solar panel and one rechargeable battery
Approximate battery operating time: 5 months (no exposure to light after a full
charge)
Specifications are subject to change without notice.
E-18
Approximate Time to
Full Charge
21 hours
78 hours
125 hours
– – –
Minute Hand
A
Click 2
Click 1
Crown
B
24 Hour Hand
Day Indicator
B
B
Split release
Reset
Display time of
second runner.
Indicators and Crown Operation
Module 5529 5530 5585
24 Hour Hand
Hour Hand
Stopwatch Minute Hand
Second Hand
Stopwatch Second Hand
Stopwatch functions
Setting the Current Time and Day
To adjust the time setting
1. When the second hand is at 12 o'clock, pull the
2. Rotate the
to change the time setting.
Crown
3. Push the
Crown
back in on a time signal to resume timekeeping.
Note
Take care that you set the correct AM or PM time.
When changing the time, move the minute hand four or five minutes past your final
setting, and then back it up to the setting you want.
Using the Stopwatch
The stopwatch measures elapsed time in 1-second increments up to 29 minutes,
59 seconds.
Elapsed time
A
A
A
Start
Stop
Resume
Split time
A
B
B
Start
Split
Split release
Correcting the 0 Positions of the Hands
Perform the following procedure if the stopwatch hands do not return to their 0 (zero)
positions when you reset the stopwatch.
1. Pull the
Crown
out to Click 2.
2. Use A (clockwise) and B (counterclockwise) to move the
and
Stopwatch Second Hand
Stopwatch Minute Hand
Holding down either button will move the second hand at high speed, until you
release the button.
The
is synchronized with the
Stopwatch Minute Hand
3. After all of the hands are the way you want, push the
Important!
Timekeeping stops while the crown is pulled out. Correct the current time setting
after performing the above operation.
Minute Hand
Click 2
A
Click 1
30
Crown
B
Day Indicator
E-11
out to Click 2.
Crown
E-13
A
B
Stop
Reset
A
B
Stop
Reset
E-15
to 12 o'clock.
.
Stopwatch Second Hand
Crown
back in.
E-17
Advertisement
