Mitsubishi Electric FR-A7AZ Instruction Manual page 18

(3) For wiring of the inverter which has one front cover, route cables between the control circuit terminal
block and front cover. If cables cannot be routed between the control circuit terminal block and front
cover due to the increased number of cables, remove a hook of the front cover and use a space become
available.
For wiring of the inverter which has front covers 1 and 2, use the space on the left side of the control
circuit terminal block.
Front cover
Inverter which has one front cover
REMARKS
When the hook of the inverter front cover is cut off for wiring, the protective structure (JEM1030) changes to open type (IP00).
When performing wiring using the space between the inverter front cover and control circuit
terminal block, take caution not to subject the cable to stress.
After wiring, wire offcuts must not be left in the inverter. They may cause a fault, failure or
malfunction.
Cut off
with a
nipper,
etc.
Cut off a hook on the inverter
front cover side surface.
(Cut off so that no portion is left.)
CAUTION
INSTALLATION AND WIRING
Front cover 1
Front cover 2
Inverter which has front covers 1 and 2
Control circuit
terminal block
2
13