INSTALLATION AND WIRING
2.3 Wiring
(1) Wire the shielded twisted pair cable after stripping its sheath to make
its wires loose.
Also, protect the shield of the twisted pair shielded cable to ensure that
it will not contact with the conductive area.
Strip off the sheath for the below length. If the length of the sheath peeled is too long, a short circuit
may occur with neighboring wires. If the length is too short, wires might come off.
Wire the stripped cable after twisting it to prevent it from becoming loose. In addition, do not solder it
Use a blade terminal as necessary.
10
Cable stripping length
5mm
Shield
(perform protective treatment)
Sheath
Shielded twisted
pair cable