Bryant 538P Owner's Manual page 11

®-
HON/OFF
~
T
(MODE)
~
fiMERON)
TEMP
8
"'<7' EIMER
OF~
( SLEEP
)
(sv.NG
DIREC~
( TURBO
)
(
LED
)
( SLEEP )
(swiNG DIREC~
( TURBO ) ( LED )
I
How
to
use the
buttons!
®
Auto operation
1. Press the MODE button to select Auto.
2. Press the UP/DOWN button to set the
desired temperature. The temperature can
be set within a range of62°F(17°C)-86°F(30°C)
in 1"F(1"C) increments.
3. Press the ON/OFF button to start the air
conditioner.
NOTE
1. In the Auto mode, the air conditioner can logically
choose the mode of Cooling, Fan, and Heating
by sensing the difference between the actual
ambient room temperature and the setting
temperature on the remote oontrol/er.
2. In the Auto mode, you can not switch the fan speed.
It has already been automatically controlled.
3.
If the Auto mode is not oomfortable for you, the
desired mode can be selected manually.
Cooling /Heating/Fan operation
1. Press the MODE button to select COOL,
H EAT(cooling & heating models only) or
FAN mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature can
be set within a range of 62°F(17°C}-86°F(30°C)
in 1"F(1"C) increments.
3. Press the FAN button to select the fan speed
in four steps-Auto, Low, Med,or High.
4. Press the ON/OFF button to start the air
conditioner.
NOTE
In the FAN mode, the setting temperature is not
displayed on the remote oontroller andy ou are not
able to control the room temperature either. In this
case,
only step 1, 3 and 4 may be performed.