Venting - Raypak RAYTHERM 0133-4001 Installation And Operating Instructions Manual

VENTING

OUTDOOR INSTALLATIONS
MODEL 133
Step 1: Remove the front (4) screws.
Step 2: Line up outdoor top vent opening over heater
vent opening.
Step 3: Lower outdoor top onto unit lining up slots in
the outdoor top with screws holes in jacket top.
Step 4: Reinstall (5) screws to secure jacket top and
outdoor top to unit.
MODELS 181-401 and 182-400
Outdoor Top Installation
Step 1: Remove jacket top panel.
Step 2: Remove and discard inner stack adapter
panel.
Step 3: Install jacket top panel.
Step 4: Insert tabs of outdoor top into keyholes located
on jacket top panel (4 places). See Detail A
Step 5: Snap tabs on outdoor top into the locked
postion of the keyhole so the top will not pull
out. See Detail B
Fig. #8114
(Part of heater)
Fig. # 9389
Detail A
(Shipped Loose with Heater)
MODELS 514 - 824
Step 1: Lower outdoor top onto unit. Position top so it
is centered on unit from side to side and front
to rear.
Step 2: Tighten the (4) screws (Shown below) until
they come in contact with the unit jacket top,
then evenly tighten all (4) screws to secure to
unit.
JACKET TOP
MODELS 926-1758
Boilers are shipped with outdoor vent terminal
factory installed.
8
Fig. #RP8280.1
Detail B
Outdoor Top
Fig. # 8166.1
FASTENING
SCREW
Fig. # 8233