Replacing A Float Switch Or The Thermostat; Replacing The Water Faucet - Frymaster Pasta Magic Service Manual

1.3.2 Replacing a Float Switch or the Thermostat

1. Drain the cookpot and disconnect the cooker from the electrical power supply.
2. Remove the screw attaching the faucet handle.
3. Remove the screws in bottom of the control panel to allow access to the thermostat or float
switch.
4. If replacing a water-level sensor (see illustration below):
a. Remove the thermostat knob.
b. Remove the four screws securing the thermostat coverplate to allow access to the sensor.
c. Disconnect the sensor lead by pulling it from its terminal then remove the Keps nut, terminal,
and washer from the sensor.
d. Inside the cookpot, remove the probe and float switch guard.
e. Inside the cookpot, remove the keeper ring from the float switch.
f. Disconnect the float switch leads.
g. Carefully disconnect the failed float switch and replace with the new switch.
h. Reassemble the washer, terminal, and nut onto the sensor, and reattach the leads.
i. Reverse Steps 1-4 to complete the procedure.
5. If replacing the thermostat:
a. Inside the cookpot, remove the probe and float switch guard.
b. Mark the wiring harness leads and disconnect them from the thermostat leads at the push-on
connectors.
c. Remove the knob.
d. Remove the four screws securing the thermostat mount.
e. Loosen the probe fitting.
f. Carefully pull the probe from the pot and replace with the new probe.
g. Reattach the leads and reverse Steps 1-3 and 5 to complete the procedure.

1.3.3 Replacing the Water Faucet

1. Drain the cookpot and disconnect the cooker from the electrical power supply.
2. Turn off the water supply to the cooker.
3. Remove the screw attaching the faucet handle.
4. Remove the two screws in bottom of the control panel to allow access to the faucet.
5. Loosen and disconnect the fittings from the faucet.
6. Remove the two screws from the faucet mounting plate.
1-4