Downloading An Application - ABB CP410 Installation And Operation Manual

7.6

Downloading an Application

Connect the RS232 port on the PC to the COM2 port on the CP410 using a
TK401 cable.
The connection can also be made according to the the illustration below:
9-pin male
RXD 2
TXD 3
GND 5
RTS 7
CTS 8
Warning:
To avoid an electrical shock, be sure to switch off the power before connecting the
download cable to the operator terminal.
Set the dip switch SW7 = ON. After the self-test, the system menu will be
displayed on the screen and the operator terminal is ready to download the
application.
Start CP400Soft and open the application file to be downloaded. Make sure that
the communication parameters are correctly configured. Also remember to
compile the file before downloading it. The file has to be compiled every time a
change has been made in the file before downloading it.
Then select Application/Download Firmware/Application in CP400Soft if it is
the first time to download the application to the operator terminal; otherwise,
select Application/Download Application. The following appears on the screen
while the operator terminal is downloading:
ABB, 1SBC159101M0201
9-pin female
2 RD
3 SD
5 SG
8 CTS
7 RTS
6 DSR
1 CD
4 DTR
Operation
19