Fujitsu AUU7RLF Design & Technical Manual page 134

9) Remote controller custom code
(Only for wireless remote controller)
The indoor unit custom code can be changed. Select the appropriate custom code.
Function number
44
10) External input control
"Operation/Stop" mode or "Forced stop" mode can be selected.
Function number
46
11) Room temperature sensor switching (Aux.)
To use the temperature sensor on the wired remote controller only, change the setting to "Wired
remote controller" (01).
This function will only work if the function setting 42 is set at "Both" (01).
When the setting value is set to "Both" (00), more suitable control of the room temperature is pos-
sible by setting function setting 30 and 31 too.
Function number
48
*: For Slim duct only.
12) Indoor unit fan control for energy saving for cooling
Enables or disables the power-saving function by controlling the indoor unit fan rotation when the
outdoor unit is stopped during cooling operation.
Function number
49
00: When the outdoor unit is stopped, the indoor unit fan operates continuously following the setting
on the remote controller.
01: When the outdoor unit is stopped, the indoor unit fan operates intermittently at a very low speed.
Setting value
00
01
02
03
Setting value
00
01
02
Setting value
00
01
Setting value
00
01
- 128 -
Setting description
A
B
C
D
Setting description
Operation/Stop mode
(Setting prohibited)
Forced stop mode
Setting description
Both
Wired remote controller
Setting description
Disable
Enable
Factory setting
♦
Factory setting
♦
Factory setting
♦
♦*
Factory setting
♦