Two-Tone Paging - Ramsey Electronics COM3010 User Manual

TYPICAL TEST PROCEDURES

3.20.05 Two-Tone Paging

This function allows the COM3010 user to open the squelch of a receiver using the Two-Tone
Paging format.
1. Connect a whip antenna on the generator RF OUT of the COM3010.
2. Set Generate frequency. Example
Enter desired RF Level. Example: 4 µV Press
3.
4. Press
5. Use the
Property of Ramsey Electronics, Inc.
6. Set Tone One, Example: 378.6 Hz
Do not reproduce or distribute.
7. Use the
8. Set Tone Two, Example: 445.7 Hz Press
9. The deviation is set to a default of 4 kHz. To change the deviation press the
button. Enter in a new deviation value. Example: 3.5 kHz, press
10. Press to access the tone type; select between the four types by using the
arrows. See the chart Below.
11. Press to send the test page.
PAGING MODE
Tone Only
Tone/Voice
Battery Save
Group Call
to access the Two Tone Paging Mode.
button to access Tone 1 frequency (0.1Hz to 3 kHz).
button to access Tone 2 frequency (0.1Hz to 3 kHz).
T1 LENGTH
0.4 seconds
1.0 second
2.7 seconds
Not Sent
T2 LENGTH SQUELCH WAIT TIME
0.8 seconds 1.3 seconds
3.0 seconds 1.3 seconds
0.8 second 1.3 seconds
8.0 seconds 1.3 seconds
46