Selecting Waypoints; Editing Waypoints; Sf Operations - Raymarine GPS navigation Operation Manual

3.6.5.1 Selecting Waypoints

To control the positioning of the list contents, the
1
(up) key lets you look at the listed waypoints at
at waypoints down the list. The waypoint # ap-
on if the [mJar m keys are pressed.

3.6.5.2 Editing Waypoints

To add a name or symbol, or edit the L/L coordinate data to
waypoint, just select-the waypoint using either method listed above. When
the memory # is highlighted, press the (EDIT1 key. This returns you to the
display so you can make the necessary changes. To Copy,
NAME WAYPOMT
Erase, or Protect a particular waypoint or event mark just select the waypoint
using either method listed above. Press the @key and the display changes
to WAYPOINT-SF.

3.6.5.3 SF Operations

If you press the m key on the Waypoint List display, you can perform
some additional operations with the stored waypoint data including the
following:
A. Protecting Waypoints
While on the Waypoint List, place the number of
the waypoint to be "Protected" in the highlighted
box on the Waypoint List. Press the msoftkey.
On the
shown under
PROTECTWPTSEVENTS
Press the ~PRoTECT wmm MmK[ sotiey to
turn "ON" the Protection feature.
When a waypoint memory is "Protected" the character "P" is displayed on
the WAYPOINT LIST
not be overwritten with new coordinate data until the protection is first turned
OFF or if a "Master Reset" of the unit is performed.
B. Erasing a Waypoint
While on the Waypoint List, place the number ofthe waypoint to be "erased"
in the highlighted box. Then press the
menu.
screen confirm that number
is correct.
and Waypoint Directory screens, and the waypoint may
q
softkey for the
.
W 71' 16. 34
I
selected
any
ON
SF
OPERATION 3-25