Before First Use; Using The Appliance - Philips HD7751 User Manual

4 Before first use
4.1 Flushing the appliance
You need to flush the coffeemaker once before
first use.
Put the mains plug in the wall socket.
1
Set the on/off switch on the back of
2
the appliance to 'i' to switch on the
appliance (Fig. 2).
• The start/standby button, the display light
up and the appliance beeps.
Note:
D
if you do not press any button within 5
minutes, the appliance goes into standby
mode. in this case, the display goes out and
only the start/standby button stays on to
indicate that the appliance is still switched on.
in standby mode, you can press any button to
reactivate the appliance.
Open the water reservoir lid. Fill the water
3
reservoir with fresh cold water up to the
10-cup indication (Fig. 3).
Note:
D
Do not put coffee beans or ground coffee in
the appliance.
Close the water reservoir lid.
4
Place the jug on the hotplate (Fig. 4).
5
Note:
D
Make sure the lid is on the jug and the jug is
properly placed on the hot plate. The spout of
the jug has to face forward into the appliance.
if the lid is not on the jug or the jug is not
properly placed, the drip stop function is
automatically activated (see chapter 'Using the
appliance', section 'Drip stop function').
Press the start/standby button (Fig. 5).
6
The appliance beeps and the freshness
•
indicator appears on the display.
Press the pre-ground coffee button to switch
7
off the grinder (Fig. 6).
• The button lights up when you press it.
Note:
D
When you switch off the grinder, the number
of cups and the strength setting are not
shown on the display.
Press the start/standby button to start the
8
brewing process (Fig. 7).
Let the appliance operate until all the water
9
has flowed into the jug.
The coffeemaker produces 5 beeps when
•
the brewing process is finished.
Press the start/standby button to stop the
10
brewing/ keep-warm process. (Fig. 5)
Empty the jug.
11

5 Using the appliance

5.1 Filling the water reservoir
Open the water reservoir lid and fill the water
1
reservoir with the required amount of cold
water (Fig. 3).
There are indications for 2 to 10 cups (275ml
to 1375ml) on the water level window and
on the jug. You can use these indications to
determine how much water to put in the
water reservoir. Keep in mind that the amount
of brewed coffee will be slightly less, since
ground coffee absorbs water.
Tip:
E
Use the jug to fill the water reservoir with the
required amount of water.
Note: (Fig. 8)
D
Do not fill the water reservoir beyond the
10-cup indication, otherwise water spills from
the opening at the back.
7