6. Pull out the next upper cassette, and check that the Adjustment Plate is correctly pushed against the frame.
CAUTION:
If the Adjustment Plate is not correctly pushed against the frame, image cannot be correctly adjusted.
When checking Cassette 3, the Between-cassette Cover needs to be removed.
7. Output and check that the margin is within the standard values.
Software Adjustment
1. Leading edge
Use the following service mode to make an adjustment.
• REGIST: 1/1 speed, front side
• REG-DUP1: 1/1 speed, back side
• REG-THCK: 1/2 speed, front side
• REG-DUP2: 1/2 speed, back side
As the value is changed by 1, the leading edge margin is changed by 0.1 mm.
2. Left edge
Use the following service mode to make an adjustment.
• ADJ-C1/ C2/ C3/ C4/ MF: Front side
• ADJ-C1RE/ C2RE/ C3RE/ MFRE: Back side
As the value is changed by 1, the left edge margin is changed by 0.1 mm.
28
5. Adjustment