Part List - Panasonic NR-B203G-S7 Service Manual

HOW TO REPAIR IF TEMPERATURE OF CRISPER IS TOO COOL
Start
Release all cabinet accessories as follow :
1
- 1 pcs of Crisper (No. 66)
- 3 pcs of PC Tray (No. 65)
Release 5 pcs of screw (Truss 4TS14) :
2
- 1 pcs at Cover Lamp (No.35)
- 1 pcs at Thermo Case (No.27)
- 3 pcs at Plat Duct PC As.(No.26)
3
Release Piece Duct PC ( No.31), Cover Lamp & Thermo Case from cabinet
Release Plate Duct PC As. from cabinet
4
Additional Moran Tape 2 layers to the Plate Duct PC As.
5
Moran Tape must be fix surely at Plate Duct PC As. and may not be pell off.
Install Plat Duct PC As. to the cabinet again.
6
Make sure Plate Duct PC. As. Fixed properly on the cabinet.
Fix Plate Duct PC As. by Truss 4TS14 (3 pcs)
7
Tighthening torque should be 80 ± 50 cN.m
Install Thermo Case As. to the cabinet.
8
Make sure Thermo Case As. fixed properly on the cabinet.
Fix Thermo Case As. By Truss 4TS14 (1 pcs)
9
Tighthening torque should be 80 ± 50 cN.m
Install Piece Duct PC & Cover Lamp to the cabinet .
10
Make sure Cover Lamp fixed properly on the cabinet.
Fix Cover lamp. By Truss 4TS14 (1 pcs)
11
Tighthening torque should be 80 ± 50 cN.m
Restore all Cabinet Accessories as follow :
12
- 1 pcs of Crisper (No. 66)
- 3 pcs of PC Tray (No. 65)
Running Test (Approximately 4 hours)
13
After finished repair, refrigerator should be run during 4 hours.
It necessary to ensure that refrigerator in stable condition before measuring.
Measure temperature on PC room (Center of Crisper).
14
(Temperature should be 0.5 ~ 5.5
Finish
o
C)
-18b-
Make sure this parts
stored on the good
place/compartment
during repairing. It to
prevent from scratch,
dented and other
defect.