Bosch TC10 Operating/Safety Instructions Manual page 22

BM 2610019162 10-11:BM 2610019162 10-11.qxp 10/20/11 8:59 AM Page 22
Straight Cut
1. Position the tile on the work table, pressed against
the work-table fence.
2. Align the tile with the blade and your desired cut
line.
3. Adjust the universal guide to the desired distance
from the blade. Use the scale rules on the sliding
work-table fence for reference.
4. Lift the ON/OFF switch to turn the saw on.
5. Wait until the blade has come up to speed and is
thoroughly wet.
6. With hands firmly placed on fence and tile at the
same time, ease the sliding work table towards
the blade to slowly feed the tile into the blade.
Continue pushing until the blade cuts completely
through the tile (Fig. 33).
7. Turn off the saw, pull the sliding work table back,
and remove the cut pieces and any debris.
flat 0°- 45° Angle Cut
1. Position the tile on the work table, pressed against
the work-table fence.
2. Align the tile with the blade and your desired cut
line.
3. Adjust the universal guide to the desired angle as
described in the "Universal Guide Adjustment" on
Saw Operations
page 17. Make sure that the tile rests against the
universal guide.
4. Adjust the universal guide to the desired distance
from the blade. Use the scale rules on the sliding
work-table fence for reference.
5. Lift the ON/OFF switch to turn the saw on.
6. Wait until the blade has come up to speed and is
thoroughly wet.
7. With hands firmly placed on fence and tile at the
same time, ease the sliding work table towards
the blade to slowly feed the tile into the blade.
Continue pushing until the blade cuts completely
through the tile (Fig. 34).
FIG. 33
8. Turn off the saw, pull the sliding work table back,
and remove the cut pieces and any debris.
CAUTION
other bevel cut will cut into the work table.
1. Adjust bevel cut as described in the "Bevel Cut
Adjustment" on page 17.
2. Position the tile on the work table, pressed against
the sliding work-table fence.
3. Align the tile with the blade and your desired cut
line.
-22-
Bevel Cut
The saw is adjustable to only three
positions (0°, 22.5° or 45°). Any
FIG. 34