Nobu IRIS Owner's Manual page 14

Clean and Maintenance
Clean heat- rem ov al pipe
Remove the heat-removal pipe from air conditioner, clean and dry it , and then
reinstall it. ( or the method of installation and removal method, please refer to the
instruction for " Installation and disassembly of heat discharge pipe" ).
Check ing b efore use- season
1. Check whether air inlets and air outlets are blocked.
2. Check whether plug and socket are in good condition.
3. Check whether lter is clean.
4. Check whether batteries is installed in remote controller.
5. Check whether oint, window bracket and heat removal pipe are installed tightly.
6. Check whether heat-removal pipe is damaged.
Check ing after use- season
1. D isconnect power supply.
2. Clean lter and outer case.
3. Remove dust and sundries on the air conditioner.
4. Eliminate accumulated water in chassis (refer to the section of " D rainage way"
for details).
5. Check whether window bracket is damaged or not. If yes, please contact dealer.
L ong - tim e storag e
If you don' t use the air conditioner for a long time, please maintain it by following
steps for good performance:
● ake sure there s no accumulated water in chassis and the heat removal pipe is
disassembled.
● Pull out the plug and wrap the power cord.
● Clean the air conditioner and pack it well to prevent dust.
Notice for recov ery
● any packing materials are recyclable materials. Please deal with them through
local recycle bin.
● If you want to throw away the air conditioner, please contact local division or
consultant service center for the correct disposal method.
12