Table of Contents
Advertisement
8 ACCESSORIES
8.1 MIG WELDING TORCH ART. 1242
Air-cooled CEBORA MIG welding torch 280 A 3,5.
8.2 PUSH-PULL UP/DOWN WELDING TORCH, air
cooled, ART. 2003 and 2009.
8.3 Cooling unit Art. 1683
8.4 Water-cooled MIG torch Art. 1241
9 MAINTENANCE
Any maintenance operation must be carried out by
qualified personnel in compliance with standard CEI
26-29 (IEC 60974-4).
9.1 GENERATOR MAINTENANCE
In the case of maintenance inside the machine, make sure
that the switch L is in position "O" and that the power
cord is disconnected from the mains.
Even though the machine is equipped with an automatic
condensation drainage device that is tripped each time
the air supply is closed, it is good practice to periodically
make sure that there is no condensation accumulated in
the water trap J (fig.1).
It is also necessary to periodically clean the interior of
the machine from the accumulated metal dust, using
compressed air.
9.2
PRECAUTIONS AFTER REPAIRS.
After making repairs, take care to organize the wiring so
that there is secure insulation between the primary and
secondary sides of the machine. Do not allow the wires
to come into contact with moving parts or those that heat
up during operation. Reassemble all clamps as they were
on the original machine, to prevent a connection from
occurring between the primary and secondary circuits
should a wire accidentally break or be disconnected.
Also mount the screws with geared washers as on the
original machine.
17
Advertisement
Table of Contents
