Armrest Receiver Attachment; Adjustable Locking Flip-Up Armrests - Quickie 2 Owner's Manual

Q U I C K I E 2
J. ARMREST RECEIVER ATTACHMENT
Mounting
1. Place the two clamp receivers (A) over the top portion of the rear side frame tube .Align with the
single post height-adjustable armrest.
2. Pinch both clamp receivers together at the armpost receiver side and insert into the armpost
receiver .
3. Once inserted, pinch both clamp receivers together on the far side of the armpost receiver.
4. Hold both clamp receivers against the top portion of the rear side frame tube and fasten(C) .
Adjustment
1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 set screws
(D) by using a 5/64" Hex Key .
2. With the armrest assembly in the receiver (B), press firmly on the outside of the
receiver.
3. Maintain pressure on the receiver and re-tighten two of the set screws (D).
4. Remove the armrest assembly and re-tighten the remaining two set screws.
5. The armrest will fit firmly in the receiver and lessen any noise that may result from
vibration.
K. ADJUSTABLE-LOCKING FLIP-UP ARMRESTS
(optional with depth-adjustable back only)
1. Adjustment
a. Loosen clamp bolts (E).
b. Move clamp up or down backrest posts to desired position.
c. Tighten bolts.
2. Angle-Adjustment
a. Loosen bolt (G).
b. Set armrest at desired angle using preset holes in armrest angle
plate (F).
c. Tighten bolt.
44 45 46 47
48
25
IX. DEALER SERVICE AND ADJUSTMENT
44
45
46
47
48
MK-100070 Rev. E