Armrest Receiver Attachment; Padded Swing-Away Armrests - Quickie 2HP Owner's Manual

E NG LIS H
J. ARMREST RECEIVER ATTACHMENT
Mounting
1. Place the two receiver clamps (A) onto the top portion of the rear side frame tube. Align with the
preferred location of the single post height-adjustable armrest.
2. Pinch both clamp receivers together at the armpost receiver side and insert the 3 hex bolts (B) into
the armpost receiver.
3. Once inserted, Hold both clamp receivers against the top portion of the rear side frame tube and
tighten the hardware (B) .
Adjusting the Armrest Fit
1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 hex bolts (D) by using a 7/16"
wrench .
2. With the armrest assembly in the receiver (C), press firmly on the outside of the receiver.
3. Maintain pressure on the receiver and re-tighten two of the hex bolts (D).
4. Remove the armrest assembly and re-tighten the remaining two hex bolts (D).
5. The armrest will fit firmly in the receiver and lessen any noise that may result from vibration.
L. PADDED SWING-AWAY ARMRESTS
Swing-away armrests can be removed or can swing away to allow lateral transfers. They are height adjustable
(1" increments) by moving Quick Release pin (E) up or down in predrilled holes on armrest bracket.
Additional height can be achieved by removing bolts (F), flipping and rotating the hardware and Receiver
Bracket (G). Ensure bolts (F) are retightend.
Swing-away, removable armrests are installed by sliding armrest into receiver (G) on back frame.
36 37 38
39
21
IX. DEALER SERVICE AND ADJUSTMENT
36
37
38
39
128226 Rev. A