Hob Check; Oven Check; Fitting The Plinth - Rangemaster 90 INDUCTION U109941 - 02 Installation And User Manual

Electrical Connection
The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.

Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double pole
switch, having a contact separation of at least 3mm in all
poles.
The cooker must not be connected to an ordinary

domestic power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect the
mains cable to the correct terminals for your electrical supply
type (Fig.7-9 and Fig.7-10). Check that the links are correctly
fitted and that the terminal screws are tight. Secure the mains
cable using the cable clamp.

Hob Check

Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.

Oven Check

Set the clock as described earlier, and then turn on the ovens.
Check the oven fans start to turn and that the ovens heat up.

Fitting the Plinth

Loosen the three screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw. Twist
and fit each end keyhole over their respective screws. Tighten
the fixing screws (Fig.7-11).
Please complete your contact details in the front of this
section. Please inform the user how to operate the cooker
and hand over the instruction pack.
Thank you.
�
�
ArtNo.130-0010 Electrical connections single-phase
������������
��
�
��
��
ArtNo.130-0010 Electrical connections 3-phase
�����
�������������
ArtNo.000-0012 - Securing the plinth
21
Fig.7-9
�����
���
Fig.7-10
����
���
�����
���
Fig.7-11