Table of Contents
Advertisement
Figure 2-Silk screen shows power supply component locations
Component Order
You'll notice that the component designations in the directions don't go exactly in order.
We have grouped them so that all components with the same value appear together. This
makes assembly easier. You'll find in the parts kit that similar parts, e.g. 3 1K resistors,
are typically (though not always) taped together.
Install the Resistors
In general, you install axial leaded components (like the resistors) by placing the body on
the silk screen side of the board, and the leads through the indicated holes. Bend the leads
over on the back of the board to keep the resistors from falling out until your solder them
in place. Try to bend the leads in a direction that won't lead to solder bridges between
traces that should remain disconnected.
We recommend the following procedure:
1. Insert all components of the same value or type
Page 7 of 36
Hide quick links:
Advertisement
Table of Contents
