Table of Contents
Advertisement
LT-300 User & Installation Manual
Connecting
This section provides relevant information for connecting the LT-300 GNSS Receiver to NMEA 0183, NMEA
2000, power, and the LT-Service Tool.
Connector and cable definition
The LT-300 GNSS Receiver has an 8-pin female connector, which is supporting simultaneously data on NMEA
0183 and NMEA 2000. The placement of the LT-300 GNSS connector is illustrated in Figure 28. A detailed
connector pin out with pin numbering is illustrated in Figure 29.
F
28: LT-300 GNSS R
IGURE
CONNECTOR USED FOR CONNECTING THE
0183, NMEA 2000,
AND POWER
The LT-300 GNSS connector has a proprietary pin out and therefore a communication cable is always
included in-the-box, see Unpacking (in-the-box) on page 5. The communication cable is available in two
lengths: 10 or 30 meters. The LT-300 GNSS Receiver is delivered including a 10 meter cable (simple-cut). The
communication cable, wire color and designation, is illustrated in Table 4.
LT-300 GNSS Interconnect Details
Pin No.
Wire Color
1
Brown
2
Yellow
3
Black
4
White
5
Blue
6
Orange
7
Green
8
Red
T
4: LT-300 GNSS R
ABLE
.
AND DESIGNATION
NOTE:
To avoid any misinterpretation, the transmit (Tx) and receive (Rx) directions are illustrated in
Figure 30, relative to the LT-300 GNSS Receiver.
Lars Thrane A/S
(
). 8-
ECEIVER
BOTTOM VIEW
LT-300 GNSS R
.
Wire Designation
TxD-
TxD+
GND
CAN_H
CAN_L
RxD+
RxD-
Vsupply
M
ECEIVER
ULTI CABLE WIRE COLOR
PIN FEMALE
NMEA
ECEIVER TO
F
30: T
IGURE
RANSMIT AND RECEIVE DIRECTIONS FOR THE
LT-300 GNSS R
www.thrane.eu
F
29: LT-300 GNSS
IGURE
CONNECTOR PIN NUMBERING
.
ECEIVER
Connecting
19 of 39
Advertisement
Table of Contents
