Table of Contents
Advertisement
[Default Policy]
Select the precondition to allow or reject the communication of other devices with the machine.
[Reject]
[Allow]
2
Specify address exceptions.
●
Enter the IP address (or the range of IP addresses) in the [Address to Register] text box and click
[Add].
Check for entry errors
●
If IP addresses are incorrectly entered, you may be unable to access the machine from the Remote UI,
in which case you need to set <IPv4 Address Filter> or <IPv6 Address Filter> to <Off>.
Filter(P. 365)
Entry form for IP addresses
Entering a single address
Specifying a range of addresses
Specifying a range of addresses with a prefix
When [Reject] is selected for an outbound filter
●
Outgoing multicast and broadcast packets cannot be filtered.
Deleting an IP address from exceptions
●
Select an IP address and click [Delete].
3
Click [OK].
6
Restart the machine.
●
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Security
Select to pass communication packets only when they are sent to or received from
devices whose IP addresses are entered in [Exception Addresses]. Communications
with other devices are prohibited.
Select to block communication packets when they are sent to or received from
devices whose IP addresses are entered in [Exception Addresses]. Communications
with other devices are permitted.
IPv6 Address Filter(P. 366)
IPv4:
Delimit numbers with periods.
IPv6:
Delimit alphanumeric characters with
colons.
Insert a hyphen between the addresses.
Enter the address, followed by a slash and
a number indicating the prefix length.
240
Description
IPv4 Address
Example
192.168.0.10
fe80::10
192.168.0.10-192.168.0.20
192.168.0.32/27
fe80::1234/64
Advertisement
Table of Contents
