Advertisement
Service Manual
Issue
Rev.
Model No: DWL Series
Circulation Pump and Motor
he dishwasher must be removed from its
installation to gain access to the circulation pump
and motor. The circulation pump can be activated
using Test Mode . Refer to schematic or strip circuit
for motor resistance value.
Before removing the circulation pump, remove the
water from the sump with a syringe.
It is important to remember the motor does not start
immediately when the dishwasher cycle has
started. If the motor hums, but will not start, make
certain the pump impeller is free from obstruction
and the motor shaft can turn freely.
The terminals on the induction motor are labeled
L1 and
through the L1 side. The wiring connector is blue to
match the wire leading to the motor. It is designed
to fit only one way on the terminals. Make certain
the connector is fully seated when installing.
- 16 -
Advertisement
