Control Techniques AXIMA 2000 Installation Manual page 10

AXIMA® 2000/4000 Multi-axis Controller Installation Manual
Manufacturer's Name:
Manufacturer's Address:
Declares that the following products:
Products Description:
Model Number:
System Options:
Conforms to the following product specification:
Electomagnetic Compatibility (EMC):
Supplementary information:
The products herewith comply with the requirements of the Low Voltage Directive (LVD) 73/23/EEC and EMC Directive 89/336/EEC
This electronic drive product is intended to be used with an appropriate motor, electrical protection components and other equipment to form a complete end
product or system. It must only be installed by a professional assembler who is familiar with requirements for safety and electromagnetic compatibility
("EMC"). The assembler is responsible for ensuring that the end product or system complies with all the relevant laws in the country where it is to be used.
Refer to the product manual for installation guidelines.
Bradley Schwartz/ VP Engineering
European Contact:
viii
Declaration of Conformity
Control Techniques
12005 Technology Drive
Eden Prairie, MN 55344
USA
AXIMA 2000/4000 Multi-axis Controller
AXIMA 2000 and AXIMA 4000
This declaration covers the above products with the stepper axis, source mode expanded I/O,
analog inputs, Modbus and Data Highway Plus.
EN 55011/1991
EN 50082-2/1995:
Sobetra Automation
Langeveldpark Lot 10
P. Dasterleusstraat 2
1600 St. Pieters Leeuw, Belgium
Class A Group 1, CISPR 11/1990 Class A Group 1
IEC 1000-4-2/1995; EN 61000-4-2, 4kV CD
IEC 1000-4-3/1995; EN 61000-4-3, ENV 50140/1993, 80% AM, 10V/m @ 3 m
IEC 1000-4-4/1995; EN 61000-4-4, 2 kV ALL LINES
IEC 1000-4-8/1993; EN 61000-4-8, 30 A/m
ENV 50141/1993, 80% AM, 10V, .15-80 MHz
ENV 50204/1995, Pulse, 900 MHz, 50% DTY, 200 Hz
February 24, 1999
Date