Advertisement
Installation Procedure
Fasten the spout with tool
8
8) Confirm with Set-up
Diagram and install the
spout (Wall Mount only)
Not included
Water supply
1
pipe
7
Attach the connector
to the controller
Mount the two water inlet
3
bracket on the wall
Connect the controller
4
to the water inlet bracket
1
Water supply pipe
STEP
Before installing the faucet, be sure to thoroughly flush away any foreign matter
such as dirt and sand trapped in the water supply pipe.
1
?
STEP
Install
10
the drain
STEP
Cut the spout
5
connecting hose
if neccessary
Connect the spout
6
connecting hose
to the controller
2
Remove the controller cover
9
Attach the controller cover
3-A
STEP
Remove the controller cover
STEP 2
2
STEP
Pull and open the controller cover to the
direction as shown right.
Controller Cover
3-A
Mount the water inlet bracket on the wall
?Mount the water inlet bracket on the
wall and temporarily tighten the screws.
?Make sure that the controller can be
attached to the water inlet bracket.
?Tighten the water inlet bracket with
the three self tapping screws.
Note: Anchors for wall may be needed.
Caution
Be sure to mount the water
inlet bracket in the correct
direction.
Otherwise, the strainer on the
water inlet bracket will be
inaccessible for cleaning.
Pull
Wall anchors
(not included)
IN
Water inlet
bracket
Self tapping screw
To be continued on the back
Advertisement
