Switching Off; Cleaning; Storage - Silvercrest SKG 1700 A2 Operating Instructions Manual

Grill oven (Figure C)
The oven function is particularly suitable for
the gratinating of food.
1. Preheat the grill plates 13 (see "Heat-
ing up" on page 48).
2. Open the lid 4 of the contact grill up-
wards. Be careful not to raise the lid
any further after it is vertical.
3. Place the food to be grilled on the lower
grill plate.
4. Lift the lid 4 up and pull it forwards and
down, until it is parallel to the lower grill
plate 13.

6.4 Switching off

1. Set both thermostat controls 9 + 15 to
the setting "•".
2. Pull out the mains plug 6.
3. Lift the grilled food off the grill plate 13
using a suitable kitchen utensil. Use e.g.
a spatula made from wood or heat-re-
sistant plastic, but never from metal.

7. Cleaning

Clean the device prior to its first use!
DANGER! Risk of electric
shock!
Pull the mains plug 6 out of the wall
socket before you clean the contact grill.
The device, the power cable and the
mains plug 6 must not be immersed in
water or any other liquids.
DANGER! Risk of injury
through burning!
Allow all the parts to cool down before
cleaning.
WARNING! Risk of material damage!
Do not use any astringent or abrasive
cleaning agents.
Clean the device after each use and remove
all food residues.
50 GB
Outer surfaces
• Clean the outer surfaces using a soft,
damp cloth with a mild soap solution.
Grease drip trays
The grease drip trays 16 may be cleaned
by hand or in a dishwasher.
Grill plates
For purposes of cleaning, remove the grill
plates 13 from the device after it has cooled
down.
1. Press the grip clamps 5 to the side and
remove the grill plates 13 from their
brackets.
2. The grill plates 13 may be cleaned by
hand or in a dishwasher. Dry them com-
pletely before re-inserting.
3. Place the grill plates into the device and
press them against the grip clamps 5
until the grill plates click into position.
NOTE: burnt-on food or fat residue is often
easier to remove if you leave a damp wash-
cloth on the baked-on residue overnight to
soften it.

8. Storage

DANGER for children!
Keep the contact grill out of the
reach of children.
• Clean all parts, and allow them to dry
properly before you put the contact grill
away.
• Figure D: wind the power cable 6
around the cable spool 7 when the de-
vice is upright.
• Select a location where neither high
temperatures nor moisture can affect the
device.