Chapter 4. Removing A Disk Storage Module - IBM BladeCenter S 7779 User Manual

Chapter 4. Removing a disk storage module

You can remove a disk storage module while the BladeCenter S system is powered
on. To remove it, open the release handles on the disk storage module, and slide
the module out of the BladeCenter S chassis.
Note: Make sure that all hard disk drive activity is stopped (the green LEDs on
any of the hard disk drives installed in the disk storage module are not blinking).
Important: If you are removing disk storage modules or hard disk drives from a
BladeCenter S chassis in which SAS RAID controller modules are installed, refer to
the IBM BladeCenter SAS RAID Controller Installation and User's Guide for additional
steps that might need to be performed.
1. Remove hard disk drives:
2. Open the release handles on the disk storage module (rotate the top handle up
3. Slide the disk storage module out of the BladeCenter S chassis.
© Copyright IBM Corp. 2013
a. Open the release handle on the hard disk drive (rotate the handle up) to
disengage the hard disk drive from the disk storage module.
b. Slide the hard disk drive out of the disk storage module.
and the bottom handle down) to disengage the disk storage module from the
BladeCenter S chassis.
7