Handling Static-Sensitive Devices - IBM BladeCenter S 7779 User Manual

v Cables for the optional modules are routed correctly.
v A failed fan module is replaced as soon as possible.

Handling static-sensitive devices

Make sure that you read these guidelines before handing static-sensitive devices.
Attention:
electronic devices. To avoid damage, keep static-sensitive devices in their
static-protective packages until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it immediately without setting
v Take additional care when you handle devices during cold weather. Heating
4
BladeCenter S Types 7779 and 8886: Storage modules
Static electricity can damage the BladeCenter S chassis and other
you.
electrostatic-discharge wrist strap, if one is available.
metal part of the BladeCenter S chassis or rack for at least 2 seconds. This drains
static electricity from the package and from your body.
down the device. If it is necessary to set down the device, put it back into its
static-protective package.
reduces indoor humidity and increases static electricity.