Table of Contents
Advertisement
Chapter 2. Installing the tape drive
Note: See the documentation that came with the server for tape-drive installation
instructions. If you do not have this documentation, use the general instructions in
this section to install the tape drive.
Installation guidelines
Before you remove or replace a device, read the following information:
v Read the safety information that begins on page iii and "Handling static-sensitive
v Observe good housekeeping in the area where you are working. Place removed
v Do not attempt to lift an object that you think is too heavy for you. If you have to
v Make sure that you have an adequate number of properly grounded electrical
v Back up all important data before you make changes to disk drives.
Handling static-sensitive devices
Attention:
keep static-sensitive devices in their static-protective packages until you are ready
to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it immediately without setting
v Take additional care when you handle devices during cold weather. Heating
© Copyright IBM Corp. 2007
devices." This information will help you work safely.
covers and other parts in a safe place.
lift a heavy object, observe the following precautions:
– Make sure that you can stand safely without slipping.
– Distribute the weight of the object equally between your feet.
– Use a slow lifting force. Never move suddenly or twist when you lift a heavy
object.
– To avoid straining the muscles in your back, lift by standing or by pushing up
with your leg muscles.
outlets for the server and all attached devices.
Static electricity can damage electronic devices. To avoid damage,
you.
electrostatic-discharge wrist strap, if one is available.
metal surface for at least 2 seconds. This drains static electricity from the
package and from your body.
down the device. If it is necessary to set down the device, put it back into its
static-protective package. Do not place the device on a metal surface.
reduces indoor humidity and increases static electricity.
5
Advertisement
Table of Contents
