NUAL FOR GAS COOKING TOPS LIVRET D’INSTRUCTIONS POUR L’UTILISA- TION ET L’ENTRETIEN DE L’ENSEMBLE POUR PLANS DE CUISSO GEBRAUCHS- UND WARTUNGSANLEI- TUNG FÜR GASHERDE MANUAL DE INSTRUCCIONES PARA EL USO Y EL MANTENIMIENTO PARA HOR- NALLAS GAS 131.7433 / 131.7463 REV. 002 / 2012...
INDICE INSTALLAZIONE Connecting to a different type of gas Avvertenze importanti OPERATING INSTRUCTIONS Posizionamento First strat-up Evacuazione dei prodotti della combustione Settings Collegamento al gas CLEANING AND MAINTENANCE Prescrizioni per l’installazione Routine maintenance Verifiche da effettuare prima Special maintenance dell’installazione. Control and safety devices Controllo della potenza Specifications table category...
INSTALLATION Important notice Read the instructions contained in this handbook carefully as they give important advice concerning safety of instal- lation, use and maintenance. Keep this handbook for any further consultation by the various operators. After having removed the packing, make sure the equipment is intact. In case of doubt, do not use the equipment and contact professionally qualified staff.
INSTALLATION Evacuation of exhaust fumes The appliances must be placed in premises from which exhaust fumes can be evacuated in compliance with in- stallation standards. Our appliances are classified type A and cannot be connected to an exhaust fume pipe. The exhaust fumes must be evacuated via extraction hoods or similar devices that are connected to an efficient flue or else they must be evacuated directly to the outside at a rate that does not fall below the specified minimum rate.
INSTALLATION Checking thermal power During initial installation and during maintenance or adaptation to another type of gas nominal heat input must be measured. It can be measured by using the volumetric method with the aid of a litre counter or a chronometer. After checking connection pressure and the diameter of the burner injectors, measure the hourly flow of the gas and compare the recorded value with the value set out in the specifications table under the heading “gas consumption”.
INSTALLATION MINIMUM ADJUSTMENT: Remove the knob and the front cover. To adjust to minimum, adjust the screw (Ref. 1): loosen to increase the flame and tighten to decrease the flame. For liquid petroleum gas, turn the screw to minimum. When the flame is in the minimum position, check that it is stable along the whole burner surface and check that when the flame is increased from minimum to maximum the flame does not go out and that the nozzle does not...
OPERATING INSTRUCTIONS LIGHTING BURNERS • Open main gas tap upstream of appliance. • Push and turn the knob from “closed” position to “maximun flame” and simultaneously press the piezoelec- tric ignition button a few times until the burner rmains lit. When first starting up, in order to keep the light ON, keep the knob pressed for about 10 seconds.