Burner; Filling With Water - Janfire Integral 25 Installation Manual

D
Installation example with store tank
A Thermostat mixer temperature limiter
B Domestic hot water supply
C Inlet cold water
D Expansion vessel
E Radiator
Note Before starting the boiler ensure that the system is filled with water, that electrical
connections are correct and that pumps are functioning.
Note The tube system should be rinsed out before the boiler is connected in order to avoid
damage from contamination to pumps and valves.

4.4 Burner

To install the burner see the burner's installation instructions below.

4.5 Filling with Water

Filling with water should be done using a fixed connection to expansion connections or with the help of a pipe
in the drain valve.
IA 32580002 EN_Ver5
O
H
Installation Instructions Janfire Pellet Boiler Integral Typ 25
A
B
C
L
H Circulation pump
K Mixing Valve
L Return radiator
O Thermo valve
© Janfire 2014
K
H
E
15(25
)