Sp2 And U7 Disable (F1); Alarm On/Off Switch (F3); Unit Display Enable (F4); Temperature Units Conversion (F5) - Process Technology DQ15D Instruction Manual

Digital temperature control

Hide thumbs Also See for DQ15D:

Table of Contents

This setting may be either a one (1) or a zero (0), and controls the behavior of the DQ15D by making it per-

form like the single Set Point PROCESS TECHNOLOGY model DE control. When this setting is set to one (1),

it is ON. The SP2 Set Point and the U7 Power Save Set Point are both disabled and will not work.

Not available.

This setting may be a zero (0) or a one (1). When set to zero, the alarm set point is turned off. When set to one,

alarm set point is turned on.

Note: The default value for this setting is zero (0).

This setting may be set to a zero (0) or a one (1). When set to one (1), the DE20 will display either a "C" or an

"F", separated by a decimal point. This indicates that either Celsius or Fahrenheit is being displayed. If the tem-

perature being measured is greater than +999 degrees, the units are not shown because the display is limited

to four positions.

This setting may be set to a zero (0) or a one (1). When set to a zero (0), the temperature is displayed in

degrees Fahrenheit. When set to a one (1), the temperature is displayed in degrees Celsius.

Conversion from F to C does NOT change set point or alarm upper limit values. These must be changed

manually.

Note: The default setting is zero (0).

This setting can be either zero (0), which is OFF, or one (1), which is ON. When ON, it enables the optional

current adder board on the DQ15D. See 4-20 mA Output Option for details on the current output signal.

If the DQ15D is equipped with the optional 4-10 mA output feature, then setting F6 to one (1) turns ON this

feature. F6 must be ON before any calibration can be performed.

The default setting is zero (0). Only active when using the optional 5416 board.

M-34-01-06 3/31/2016

F1, SP2 and U7 Disable

F2, Heating or Cooling Switch

F3, Alarm On/Off Switch

F4, Unit Display Enable Flag

F5, Temperature Units Conversion

F6, Current Output Enable Flag

DQ15D/T-DQ15D Manual

Table of Contents

Show Quick Links

Table of Contents

T-dq15d