Configuration (Setup) - Process Technology DQ15D Instruction Manual

Configuration (Set-up)
1 To configure the DQ15D, press
simultaneously and hold for approximately 6
seconds. The screen displays
2 While the is flashing, use
0
to . Press . The control will be in the
11 SET
configuration mode. While in this mode, the
screen displays the values of various configu-
ration settings. The first setting to display is
the setting. See setting summary. By using
U1
keys, it is possible to scroll through
and
the list of settings to those needing modifica-
tion.
Adjust Configuration Setting
1 To adjust a setting while in the Configuration
Mode, use and
ting into the view on the screen.
2 Press SET to change the value of the setting.
Once SET has been released, the display will
flash.
3 Use and to scroll through the options for
the selected setting.
4 After the option has been determined, press
once more to lock the new value into
SET
memory.
5 After completing all changes to the configura-
tion of the control, the new configuration must
be saved. To save the new value, press
simultaneously. This will cause the control to
store the new values internally and then reset
the unit.
Note: Switching off power to the unit before saving the new con-
figuration will cause all changes to be lost.
M-34-01-06 3/31/2016
and
.
AC.0
to change this
to bring the particular set-
and
Sensor DIP Switch
When using the sensor 5416 or 5447 boards, an
on-board DIP switch must also be configured.
Sw Sw Sw
1 2 3
OFF OFF OFF 1000 ohm RTD
ON OFF OFF 100 ohm RTD
OFF ON OFF voltage
OFF OFF ON
OFF OFF OFF frequency
14
Type
current
DQ15D/T-DQ15D Manual