Table of Contents
Advertisement
Indesit
Company
AUTOMATIC CLEANING USING THE PYROLYTIC CYCLE
The cleaning cycle can cause the internal temperature of the oven to reach 500°C. The pyrolytic cycle
is activated, burning away food and grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven as a result of the combustion process. There is no cause
for concern: this process is both normal and hazard free.
Before initiating the PYROLYTIC cycle:
•
Clean the oven door;
•
Remove large or coarse food residues from the inside the oven cavity and door glass using a
damp sponge. Do not use detergents;
•
Remove all accessories and the sliding rack kit (where present);
•
Do not place tea towels or pot holders over the oven handle.
If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to cool down.
The programme may only be started once the oven door has been closed.
To activate the cleaning cycle
1. Press
to switch on the control panel.
2. Press the
icon.
3. Scroll through the menu commands using the control dial, select PYROLYTIC and press
4. The appliance suggests a "NORMAL" pyrolytic cycle, with a duration of 1 hour 30 minutes. Other
levels of cleaning may be selected.
•
Use the control dial to select one of the following:
- 'ECONOMY': duration 1 hour
- 'NORMAL': duration 1 hour and 30 minutes
- 'INTENSIVE': duration 2 hours.
•
Press
again.
5. Press icon
to begin the PYROLYTIC cycle.
Safety Devices
•
The door locks automatically as soon as the temperature reaches a high value; the
up on the display.
•
Pressing the
icon cancels the cleaning cycle at any time.
•
If a malfunction occurs, the heating elements will be switched off.
•
Once the oven door has been locked, you cannot change the duration and end time settings.
Programming Delayed Automatic Cleaning
Programming is possible only after selecting the cleaning cycle.
1. Press the
icon twice; the end of pyrolysis time will begin to flash.
2. Turn the control dial to adjust the end of pyrolysis time; hold the dial in this position to scroll
through the numbers more quickly and make the setting process easier. The display will show a
graphic indicating the delayed start in bar format.
3. Once you have reached the desired end time, press the
show the current time, the time remaining until the start of pyrolysis, the duration and the end of
pyrolysis time as a graphic.
Service Manual UK
:
31 of 49
icon again. The delayed start bar will
.
icon lights
English
Hide quick links:
Advertisement
Table of Contents
