Cleaning The Oven Door; Replacing The Light Bulb; Automatic Cleaning With The Fast Clean Function - Hotpoint SH103PX S Operating Instructions Manual

Cleaning the oven door

GB
Clean the glass part of the oven door using a sponge and a non-abrasive
cleaning product, then dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these could scratch the surface
and cause the glass to crack.
To clean the oven more thoroughly, you can remove its door:
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
12
1. Open the oven door fully (see diagram);
2. Lift up and turn the small levers located on
the two hinges (see diagram);
3. Grip the door on the two external sides
and close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram).

Replacing the light bulb

Oven
compartment
Lamp
Seal (only on a
few models)
Glass door
! Do not use the oven lamp as/for ambient lighting.

Automatic cleaning with the FAST CLEAN function

With the FAST CLEAN mode, the internal temperature of the oven reaches
500°C. The pyrolytic cycle is activated, burning away food and grime
residues. Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause for concern: this process
is both normal and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where present);
• do not place tea towels or pot holders over the oven handle.
! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to
cool down.
! The programme may only be started once the oven door has been closed.
To activate the Fast Clean programme:
1. Switch the control panel on by pressing the
2. Press the button; the TIME display will show the default duration of
1:30 h (normal cycle), while he TEMPERATURE display will show "Piro" and
"nor" alternately;
3. The desired cleaning level can be selected by pressing the
- pressing to switch to the intensive cycle: the duration is 2 h and the
TEMPERATURE display shows the text "Piro" and "int" alternately;
- pressing to switch to the economy cycle: the duration is 1 h and the
TEMPERATURE display shows the text "Piro" and "eco" alternately.
Safety devices
• the door locks automatically as soon as the temperature reaches a high
value; the icon lights up on the display;
• pressing the button cancels the cleaning cycle t any time;
• if a malfunction occurs, the heating elements will be switched off;
• once the oven door has been locked, you cannot change the duration and
end time settings.
*
Only available on certain models.
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and
replace it with a similar one: Wattage
25 W, cap E 14.
3. Replace the glass cover (see
diagram).
button.
button, then: