Deleting Messages; Screening Calls; Using Call Breakthrough; Changing The Cbt Code - Radio Shack TAD-705 Owner's Manual

43-705.fm Page 18 Tuesday, May 23, 2000 8:54 AM
• the TAD's memory is full
The recorded conversation is stored as a
message (see "Playing
Page 16).

DELETING MESSAGES

To delete a specific message, press
while the message is playing. The TAD
beeps and deletes the message, then plays
the next.
To delete all messages, stop playback and
hold down until
DELETE
9 9 9 9 ; ; ; ;
then press / .
The TAD does not delete new messages. If
you hold down
DELETE
delete only new messages, the TAD sounds
four beeps.

SCREENING CALLS

To screen calls, let the TAD answer them.
TAD IN USE appears.
TELEPHONE ANSWERING SYSTEM
AM
O M1 O M2
CALLER ID
/ /
DELETE
Listen to the caller's message through the
TAD's speaker. To adjust the volume, slide
SPEAKER VOL MIN/MAX
the TAD (see "Adjusting the Volume" on
Page 11).
If you decide to answer the call, pick up any
phone on the same phone line as the TAD.
The TAD stops recording and resets to an-
swer the next call.
If you do not want to take the call, let the
TAD finish recording the caller's message.
18
Messages" on
DELETE
appears,
dEL ALL
9 9 9 9 ; ; ; ;
then press / to
CALL
NEW
ANS ON
DIAL
on the right side of
TAD Operation
Note: If you answer the phone just as the
TAD answers, the TAD might not stop play-
ing the outgoing message. If this happens,
press .
STOP
USING CALL
BREAKTHROUGH
If you screen your calls but want to know
when calls come in from certain people, give
them your Call Breakthrough (CBT) Code.
When a caller enters the CBT code during
the outgoing message, the TAD alerts you
with a series of loud beeps for 35 seconds.
To answer the call, pick up the handset. If
you do not answer, the caller can leave a
message after the outgoing message plays.

Changing the CBT Code

The CBT code is preset to 168, but you can
change it by following these steps.
Note: If you do not complete each step with-
in 8 seconds, the TAD exits setup. Start
again from Step 1.
1. Hold down until the TAD beeps
STOP
once.
2. Press four times.
DIAL
CBT CODE appear.
: : : :
3. Repeatedly press
9 9 9 9
digit, then press /
flashes.
Note: If you make a mistake, repeatedly
9 9 9 9 ; ; ; ;
press / until the desired digit
flashes then re-enter the code.
4. Repeat Step 3 to set the second and
third digits.
5. Press then press
DIAL
the time display.
168 and SET
1 flashes.
8 8 8 8
/ to set the first
; ; ; ;
. The second digit
to return to
STOP