Tait TP9100 Service Manual page 96

Table 4.7 CCTM commands for the user interface
CCTM command
513 - Generate audible indicator
Sounds a programmed audible indicator on the
radio
804 - Read volume potentiometer
Returns the current volume pot level
820 - Battery monitoring
Start or stops a log of battery information such
as voltage and temperature
855 - LCD
Alters or resets the radio's LCD
Table 4.8 CCTM commands for digital P25 mode
CCTM command
700 - Radio mode
Sets the radio's mode of operation (analog FM or
digital P25)
714 - Transmit P25 test pattern
Transmits a 1011Hz audio tone test pattern
96 General Information
Entry at keyboard
513 x
where x is an integer from 1 to 85
804
820 1 = start log of battery
information (returned every ten
seconds)
820 0 = stop log
855 x
where x is the command for the
LCD (0 to 255, for example, 165
turns all pixels on, 164 reverts to
normal pixel display, 167 inverts
display, 166 turns invert off, 65 to
127 sets display start address)
Entry at keyboard
700 x
where x is the mode (0=analog FM
mode, 1=digital P25 mode)
714 4
Response on screen
none
x
where x is the raw
volume pot ADC
value. This reading is
inversely proportional
to the set volume
level, and will be
approximately 100 to
950.
Charging, Temp,
PackV, SubPackV,
Current, PackT, Cap,
DisT, EndOfChargeT,
LastCapM,
CapCorrection,
LastChargeT,
StatusMsg
none
Response on screen
none
none
TP9100 Service Manual
© Tait Electronics Limited May 2005