Ford 2005 Mustang Disassembly And Assembly page 8

501-10-8
DISASSEMBLY AND ASSEMBLY (Continued)
Seats with side air bags
6. WARNING: Inspect the mounting
surfaces of the side air bag module and the
seat back frame mounting bracket for any
foreign objects before installing the side air
bag module. If any foreign objects are found,
remove them. Failure to do so may result in
personal injury, in the event of an air bag
deployment.
WARNING: Before installing the side
air bag module, check it for damage and
foreign objects. If the air bag module is
damaged, install a new one. If any foreign
objects are found, remove them. Failure to
do so may result in personal injury, in the
event of an air bag deployment.
WARNING: Inspect the side air bag
cavity in the seat back pad for any foreign
objects. If any foreign objects are found,
remove them. Failure to do so may result in
personal injury in the event of an air bag
deployment.
WARNING: If the air bag cover has
separated or the air bag material has been
exposed, install a new side air bag module.
Do not attempt to repair the air bag module.
Failure to do so may result in personal
injury in the event of an air bag deployment.
CAUTION: Make sure the side air bag
module wiring harness is not pinched
between the side air bag module and the
mounting bracket.
Position the side air bag module bracket to the
backrest frame, install the bolts and install the
wire harness pin-type retainers to the backrest
frame.
• Tighten the bolts to 10 Nm (89 lb-ft).
Seating
All seats
7. Position the backrest frame into the backrest
foam pad.
8. Position the backrest trim cover to the top of
the backrest.
9. WARNING: To correctly retain the
backrest trim cover and allow correct
deployment of the seat side air bag module,
make sure to install 2 hog rings to attach the
backrest trim cover wire to the listing wire
in each foam pad window. Failure to follow
this instruction may result in personal injury
in the event of a seat side air bag module
deployment.
Roll the backrest trim cover down and install
the second row of hog rings.
1 Install the 2 hog rings per window as
shown.
2 Attach the hook and loop strips.
501-10-8
2005 Mustang, 12/2004