Ford 2005 Mustang Disassembly And Assembly page 9

501-10-9
DISASSEMBLY AND ASSEMBLY (Continued)
10. WARNING: To correctly retain the
backrest trim cover and allow correct
deployment of the seat side air bag module,
make sure to install 2 hog rings to attach the
backrest trim cover wire to the listing wire
in each foam pad window. Failure to follow
this instruction may result in personal injury
in the event of a seat side air bag module
deployment.
Roll the backrest trim cover down and install
the first row of hog rings.
1 Install the 2 hog rings per window as
shown.
2 Attach the hook and loop strips.
11. Attach the backrest trim cover inner J-strip.
12. Attach the J-strip at the bottom of the backrest
trim cover.
Seating
13. Slide the backrest recliner release bezel upward
to engage the clip, install the screw.
14. Install the backrest recliner release handle.
15. Fold the backrest trim cover over on each side
of the inboard and outboard recliner. Install the
plastic rivets attaching the backrest trim cover
to the inboard and outboard recliners.
16. NOTE: The head restraint guides are not
interchangeable.
Install the 2 head restraint guides.
17. Install the head restraint.
18. Install the front seat backrest. For additional
information, refer to Front Seat Backrest in this
section.
19. Install the seat. For additional information, refer
to Front Seat in this section.
20. Repower the SRS. For additional information,
refer to Supplemental Restraint System (SRS)
Depowering and Repowering in the General
Procedures portion of Section 501-20B.
501-10-9
2005 Mustang, 12/2004