Ford 2005 Mustang Disassembly And Assembly page 6

501-10-6
DISASSEMBLY AND ASSEMBLY (Continued)
Assembly
Seats with power lumbar
1. Slide the backrest support assembly rods into
the backrest frame at the top and attach the 2
pin-type retainers at the bottom. Install the side
springs.
• Make sure the side springs are between
wires 6 and 7 when starting to count from
the bottom up.
Seats with power lumbar
2. Slide the lumbar adjust assembly rods into the
backrest frame at the top and attach the 4
pin-type retainers at the bottom.
Seating
All seats
3. Position the backrest recliner release with cable
and install the 2 rivets.
• If necessary, install a tie strap holding the
cable to the backrest frame.
4. Route the backrest recliner release cable as
noted during disassembly and install the cable
and casing to the outboard recliner.
501-10-6
2005 Mustang, 12/2004