Configuration - ABK i-Cooking Instruction Manual

5.3 Configuration

Before the first use, the controls of the
appliance must be configurated. In this
procedure, the individual cooking zones
are assigned to the positions on the
control panel. Execute the following steps.
1 Remove pans from the cooking zones.
2 Switch-off the electrical tension with the
fuse or main switch in your meter
cupboard.
3 Wait at least 2 minutes before you
switch on the electrical tension again.
4. Start the configuration within 2 minutes
after the tension is switched on again.
Take a pan with a diameter of 16cm, do not
use different pans within the configuration
process.
Removing an existing configuration
A. Press the symbol "p" and keep it
pressed. On the control panel the indicator
lights of the zones now light up.
B. Keep the "p" pressed and use your other
hand to quickly press each zone display,
counterclockwise starting from the right
side below. Do this total process within 2-
3 seconds. You will here a confirmative
beep when you press each display. In case
of a succesful proces, in each zone a
minus sign appears. If you hear a double
beep, you must repeat the procedure from
step A.
C. Release all switches and now press the
on/off switch during several seconds,
unless blinking "E" codes appear.
D. Wait until the "E" codes stop blinking.
After a few seconds the "E" codes will
change into "C" codes
Attention! To configurate a 3-zones set the
procedure starts from the top right side
instead of the below right side.
New configuration
Take a pan with a diameter of 16cm, do not
use different pans within the configuration
process .
E. Select the cooking zone position by
pressing the corresponding code "C" in
the display. Now place the pan onto the
zone and wait untill the code "C" changes
into code "-". The zone is now assigned.
F. Repeat the procedure of E to assign the
remaining cooking zones. After all zones
have been allocated, the codes "-" in the
display dissapear.
The application is now ready for use!
Code E4
Reconfigure the zones and control again,
start with removing the old configuration.
If this does not help, please contact your
supplier.
.
EN 21 Installation